Club 3D's Multi Stream Transport (MST) Hub is now available in Switzerland and is currently selling at Digitec.ch for CHF 126. In case you missed it earlier, the Club 3D MST Hub basically transforms a single DisplayPort 1.2 output to additional three DisplayPort outputs.

Since the DisplayPort 1.2 adds the capability to address and drive several display devices via one DisplayPort connector, the Club 3D MST Hub simply receives a DisplayPort 1.2 MST signal from the source device and splits up and routs the video stream independently to each display device. The Club 3D MST Hub also allows the use of non-DisplayPort 1.2 monitors as it actively converts the DisplayPort single to other types of display interface signals including VGA, DVI and HDMI.

As far as the specs go, the Club 3D MST Hub supports main link rates of 5.4 bps(HBR2), 2.7 bps(HBR) and 1.62 bps(RBR) from source, supports three DP++ output port,or two dual-link DVI ports (or the combination of ports), supports DP1.2 MST multi video/audio streams as well as Displayport 1.1 source with ViewXpand support, support DP-DP bypass mode, and feature support output resolution of up to 2560X1600@60Hz for each monitor in DP1.2 MST and up to FHD/1080p in DP1.1 or DP 1.2 SST modes.

The CHF 126 price tag might sound a bit steep but considering that you get three DisplayPort (or any other interface signal) without use of bulky adapters and actually need three DisplayPort outputs, the Club 3D MST Hub sounds like a great deal.





Source: Club-3d.com, Digitec.ch.