Quote:
Quote:

Thank you guys...

It starts to go to settle finally the 4 corners.....




Done.

Ok ... i get it ... you want to put your car in the case ...

Here we are after a break ....

Today I realized support for HD 4TB




Leaving a space below , for the passage of air::*




Then begin with the drilling on the plate , for the passage of cables :: *







And there it settled :: *




Now is the time to fix and drill support of 2 usb3 , I took on Amazon :: *




And after playing with a small file , here it is how the finished :: *

Try filling with distilled water



https://www.youtube.com/watch?v=futLwn-dS3E

And finally came the stainless steel structure.
Now I just have to make 2 holes to fix the wall, with 2 threading bars from 12mm, which will pass the wall for greater safety .
On the center bar will set you see, at the right height plaque tiltable, rotatable and, where staring at the screen.

Now once took measures start to make a few holes on the bar will go to support the screen ... to fix his plate :: *







And finally fixed plaque ... you see the various holes are being made, to adjust the height of the screen , in case of replacement, with a larger :: *







Finally here it is set :: *

Here we go guys, the final stages ....
I begin to assemble the grids, and the fans on the side::*




Then I do a test with the 2 Lamptron::*




Now I make all electrical connections::*







And now I begin to fill the entire system, with a syringe, filling it up, to bleed the air.

Some pictures::*

Stunning job! It looks absolutely great!