Quote:

Haha yea that's about it

Those are some seriously mean folks over there at Tt They really could have spared some more rivets for you ... it's not like they're expensive

Quote:

Hahaha I will probably need to replace some, not sure yet so far I have nuts and bolts holding it together while I work on it. I will need to finish all the case mods and then get it over to powder coating and also paint some of the other bits before assembling it properly.

Back with another update!

Playing around with ideas in the other case



And making progress on the main case











I had an idea with the original mesh but probably not gonna keep it







That's about it! I need to secure the rad mounts on the side and mount some rads in to test fitment.

Stay tuned for more!

Cheers,

Alex

Sweet It's about to become an X9-train :O

Quote:

Hahaha I just noticed that after reading your comment

Hey guys!

I have secured the side rad mounts and mounted two of the 480mm radiators going in this build just to get a feel for how much room there will be in that section of the case.

Also the radiators on the bottom of the other case are mounted on an angle like that but I'm probably not gonna go with that idea. They will most likely go with two sets of fans on them mounted to the bottom of the case. The LEDs from the Riing fans should give it a nice underglow



Also front panel still looks the same from last time however I will most likely get rid of the mesh and redo the whole front.





Pump/res combo should fit nicely under the motherboard tray. A new motherboard tray will be going in











Thanks for checking it out!

Cheers,

Alex

Seriously ... the cooling is definitely insufficient! You should use a low power CPU. High-end stuff will definitely overheat :O

Quote:

Hahaha yea definitely, there would be room for even more rads hahaha

Quote:

Aaawwweee ... that's cute