Advertisment
Browsing this Thread:
1 Anonymous Users
LucaRocchi
- Started insulating
- Joined: 2012/8/31 20:29
- From Milan, IT
- Group: Registered Users Webmasters
- Posts: 2228
- Posted on: 2013/4/6 14:32
[Modding] Corsair Hydro H50
#1
This H50 was purchased a few months ago overused and dirty
H50:
Kit list:
-Fitting 6/8mm
-Tubing 6/8mm
-Res [EKWB 100 X2 BASIC]
-Cutter
-ZipTie
-Phillips screwdriver
-Time and patience
Some temps from OCN.net
Quote:
Phenom II 955BE C[B]2[/B] @ 3.8GHz (200x19) 1.425v
H50 = 59^C Prime95
H50/Lapped CPU = 52^C
Lapped/Modded H50/Lapped CPU = 48^C
Lapped/Modded H50/Lapped CPU @ 3.9GHz/1.52v = 55^C
Phenom II 1055T @ 4.0GHz (286x14) 1.475v
Prime95 Full Load 1h
H50 Stock = 56^C
H50 Modded = 45^C
Not so bad! And are also C2 and not C3
Project:
Let's start!
First you need to remove the plastic cap that covers the WB, unscrew two screws located under the plastic, exactly these:
Tubing removed!
Sleeve is always nice
My RES is damaged, so I have used some teflon tape.
The WB is very ugly and dirty, used and abused..so I have decided to lap its!
I have started with 500, 800 and then 1000.
Some pics!
Its my first work, not so bad, right? About 2h
The support for my RES!
All done finally
Perfomance? CPU is 10C colder!
A friend is using it, on 955BE without any problem
