Review: Lian Li PC-Z60
Published by Marc Büchel on 04.01.12Page:
Front
Overview |
|
 |
|
| The front of Lian Lis PC-Z60
simply elegant and therefore timeless. In the bottom area the only thing
you find is a the Lian Li logo. Removing the front panel reveals five
hot swap cages which need to "front-loaded". To do so you need to equip
the hard drives with guide rails on both side. Once you've done so you
can simply slide them in place. On the face side there are two audio jacks (headphone out and microphone in). Furhtermore you'll find two USB3.0 as well as one USB2.0 ports and an eSATA connector. |
|
Back
Overview |
|
| Next to the usual slot bezels of which you're going to find eight, there is an 120 millimeter fan which is placed right behind the CPU cooler. In general the back of this case looks quite unspectacular. Both side panels are kept in place by the use of four thumbscrews. Right below the 120 millimeter fan there are two grommets through which you can either route cables or tubes from your water cooling. | |
| Page 1 - Introduction | Page 5 - Left side |
| Page 2 - Preview | Page 6 - Top / Bottom |
| Page 3 - Front / Back | Page 7 - Temperatures |
| Page 4 - Right side | Page 8 - Conclusion |
Discuss this article in the forums
| Navigate through the articles | |
Review: SilverStone TJ08-E |
Coolermaster CM690 II Advanced USB 3.0
 |
|
|