Lancool K63
Published by Marc Büchel on 25.07.11Page:
Back
Overview |
|
 |
|
| Next
to the usual slot bezels of which you're going to find eight, there are
two in/outlets for watercooling tubs. Right next to the hole
where the I/O panel will be placed once you put a board into the case,
there is mesh metal behind which either a 120
millimeter fan has been pre-installed. Generally the back, as well as the front, leaves a well structured impression. |
|
| At this point you see the hole for the power supply from the outside as well as from the inside. If you should choose to mount the power supply with the fan facing downwards, it can easily suck in fresh air through the ventialtion slots. Furthermore the power supply lies on two rubber feet, which are quite hard and they therefore wont damp any vibration. | |
| Page 1 - Introduction | Page 5 - Left side |
| Page 2 - Preview | Page 6 - Right side |
| Page 3 - Front | Page 7 - Top / Bottom |
| Page 4 - Back | Page 8 - Conclusion |
Discuss this article in the forums
| Navigate through the articles | |
BitFenix Survivor Core |
Review: SilverStone TJ08-E
 |
|
|