IN WIN DragonRider
Published by Tanya Rothenburg on 05.01.11Page:
Back
Overview |
Features |
 |
  |
| On the backside you find an outtake fan with a diameter of 90 millimeters. In Win mounted the fan in order to move hot air out of the case to the environment. Right below you find a total of eight slots bezels which allows the installation of up to eight expansion cards. | If you want to remove the side panels you can do that by releasing the thumbscrews. You will notice that In Win provided the Dragon Rider with very well manufactured screw threads. On the top part you can see four holes protected by rubber covers. One of them is used by the USB 3.0 cable originating from the front panel. To use the front panel USB 3.0 connectors you'll have to attach the mentioned cable to the connectors at the back of the motherboard. |
  |
 
|
| At this point you can once again see the eight slots bezels as well as one of the thumb screws which can be released or tightened very easily because of their comfortable size. | With the Dragon Rider you have to mount the power supply unit at the bottom of the case. Right below the PSU there are ventilation holes which are covered by a plastic air filter to prvoide dustfree air. |
| Page 1 - Introduction | Page 5 - Left side |
| Page 2 - Preview | Page 6 - Right side |
| Page 3 - Front | Page 7 - Top / Bottom |
| Page 4 - Back | Page 8 - Conclusion |
Discuss this article in the forums
| Navigate through the articles | |
Lian Li Test Bench PC-Q06 |
Lian Li PC-X2000FB
 |
|
|