Enermax iVektor Review
Published by Luca Rocchi on 05.03.14Page:
Front
Overview |
 |
| Compared to previously analyzed Fulmo ST, the iVektor has a design with soft lines and is a bit more rounded. The materials, after an initial analysis, are of good quality and workmanship. The front of the iVektor is entirely made of ABS and covered with a white color softouch finish. The upper part of the case features three 5.25" bays and the lower part is taken by the silver Enermax logo. Behind the front mesh there are the two 120mm fans placed to cool down the HDDs. |
Back
Overview |
 |
| The rear part, like the bottom one, is made of black SECC steel. In the upper part there is a place for the rear fan and two rubber grommets for liquid systems. The area devoted to the power supply is located at the bottom of the case, and the housing is comfortable and very spacious so you can even install big PSU without any problems. |
| Page 1 - Introduction | Page 5 - Left side |
| Page 2 - Preview | Page 6 - Top / Bottom |
| Page 3 - Front / Back | Page 7 - Conclusion |
| Page 4 - Right side |
| Navigate through the articles | |
Enermax Fulmo ST Review |
BitFenix Prodigy M Review
 |
|
|