Cooler Master N600 Review
Published by Francesco Daghini on 15.10.13Page:
Front
Overview |
 
 |
| The new Cooler Master N600’s design is clean and elegant, thanks to the black finish and the front covered with mesh. Behind it you will find space for up to two 120 mm fans, whereas one is pre-installed. Cooler Master ships this case with a pre-installed LED Xtra Flow 120 mm fans. On the right hand side, you'll find a piece made from plastic looking like brushed aluminium. Integrated into this bar there are the front I/O connectors. Cooler Master decided to equip the N600 with two USB 2.0 ports, two USB 3.0 ports, a headset and microphone connector, Start button, Reset button, and a switch which allows you to enable/disable the fan's LEDs. Furthermore, there are three 5.25 inch slots. |
Back
Overview |
 |
| In the bottom, there’s the PSU housing, which offers space for a standard ATX power supply. Above that, there are 7+1 expansions slots. Other than that, we find the the cut-out for the motherboard I/O panel, and behind a mesh there is another 120 mm fan with 3-pin connector. There are also a couple of holes, with rubber grommets for liquid cooling tubes. In the top left corner there is a small switch, that lets you set two different fan speeds. You actually get a high and a low setting for up to two fans. |
| Page 1 - Introduction | Page 5 - Left side |
| Page 2 - Preview | Page 6 - Top / Bottom |
| Page 3 - Front / Back | Page 7 - Conclusion |
| Page 4 - Right side |
| Navigate through the articles | |
Corsair Obsidian Series 750D Review |
Cooler Master Cosmos SE Review
 |
|
|