Bundle et Spécifications

Bundle
Câbles	Longueur
1 x ATX 20+4 pins	60  cm
2 x EPS/ATX 12V 8 & 4+4 pins	65 cm
8 x PCI-E 6+2 pins	60 cm
1x2 + 3x3 SATA	55, 90 cm
1x2 + 2x3 Molex + 1 x 2 Floppy	55, 90 cm

The delivery of the P1-1250-BEFX is adequate. Since PSUs with this kind of output power are often used for PCs with five or more graphics cards, it would have been nice if XFX added another pair of PCI-E 6+2 Pin cables, which can be connected to the EPS/ATX 12V 8Pin connector.




The design is based on one single 12V rail with a whopping 104A. However this 12V rail is then splitted into four rails for distribution. The four rails are then OCP protected induvidually. In our opinion it is good that the manufacturer splitted the rail (for security reasons) but it would been even better if XFX mentions it somewhere in the descriptions.
Aditionally we think, that the four Rails are too heavily OCP protected. Even with normal usage (within the specs) it could be that this device goes into OCP status (for example: a 45A Rail providing four PCIe 8Pin - with two Radeon HD 6990 cards on them this rail would go OCP). It's very sad that XFX does not provide the correct information at this point.

Spécifications (d'après XFX)
Tension	Courant	Puissance
+ 3.3 V	25 A	150 Watt	1'250 Watt (Total)
+ 5.0 V	25 A
+ 12 V	104 A	1'248 Watt
- 12 V	0.5 A	6 Watt
+ 5 Vsb	3.0 A	15 Watt

This PSU is based on one 12V rail that offers 104A. However this rail is split internally into four separate rails.
How the power has been split on the different rails can be seen in the following table:

Spécifications (réalité)
Tension	Courant	Puissance
+ 3.3 V	25 A	150 Watt	1'250 Watt (Total)
+ 5.0 V	25 A
+ 12 V1	30 A	1'248 Watt
+ 12 V2	30 A
+ 12 V3	45 A
+ 12 V4	45 A
- 12 V	0.5 A	6 Watt
+ 5 Vsb	3.0 A	15 Watt

The Rails are connected to the connectors as follows:

• 12V1 - 30A
  - 24Pin ATX
  - 2x EPS/ATX 12V 8Pin
   
• 12V2 - 30A
  - 2x PCI-E 6+2 Pin
   
• 12V3 - 45A
  - 4x PCI-E 6+2 Pin
   
• 12V4 - 45A
  - Molex
  - SATA
  - 2x PCI-E 6+2 Pin

The manufacturer has done this in quite an odd way. We understand that a single rail with 104A is potentially dangerous. However we would like to see an optimized rail distribution as well as a more useful OCP protection per rail. 4 x 55A or similar would make sense in our opinion.




The P1-1250-BEFX has been 80Plus Gold certified. This means, that the efficiency of this PSU should be above 87% at 20% load, above 90% at 50% load and above 87% at 100% load.
Feature-list:

• 80Plus Gold
• OVP, UVP, OCP, SCP, OPP, OTP
• Dimensions (L x H x P): 150 mm x 86 mm x 190 mm
• Ventilateur de 135 mm
• Semi-passive (inaudible en dessous de 20 % de charge)
• Garantie: 5 ans
• Prix: 250 CHF

---

Page 1 - Introduction

Page 2 - Aperçu

Page 3 - Bundle / Specs

Page 4 - À l'intérieur

Page 5 - Puissance d'entré/sortie et rendement

Page 6 - Analyse des résultats et discussion

Page 7 - Conclusion