Re: CM Cosmos II Modern by Dave2010
#10
I'm back folks, I recovered.
Since the speech aluminum stalled for some time, I proceeded to design the whole thing in steel. I will spare you the tables of the various panels in 2D because soon you will see them realized.
We begin with an overview of the various pieces that I designed and made to realize laser.
Support for radiator 4802 mm thick. The radiator accommodated in the front area with fans in mining, placed inside, attached to the radiator.
I was thinking of a small conveyor plexi, perhaps to illuminate. The triangle above has been obtained to be able to see the logo Phobya, not for a specific reason, but because I like it.
The piece will be fixed so as you see it, anchoring it with the part below the bottom of the case.
Rear PanelsThese two panels will be placed in the rear of the cabinet, where there is currently preparing for the 140 mm fan.
The latter will be present throughout sdremellato to leave only the little frame side where I will set these two panels, one inside and one outside. The internal one has a thickness of 1 mm (right panel) and the external instead (left panel) has a thickness of 2 mm, because as noted ... I'll have to hold the power supply, mounted vertically with connections to the inside and the side with the switch and the connector 230 V fixed on the panel.
360 mm radiator grill1 mm thick, is placed above the radiator fans: the latter will be positioned on top of the case, with extraction fans in inland homes.
Support SSDConsists of two pieces, 1.5 mm thick, will be assembled as you can see in the second picture, and placed vertically as you see the last one, with the visible side anchored to another panel that we will see later. The SSD will be set using the holes of the same, using the screw holes on the side that I have prepared.
The pieces are a little 'dirty, tomorrow I will take to clean them well and proceed to the early stages of working to integrate them.