Drobo 5N2 Review
Category : Storage
Published by Marc Büchel on 13.04.17
The 5N2 is the successor of the 5N, which we've already reviewed last year. On the inside there is now an upgraded quad core SoC running at 1.6GHz (1.2GHz with the 5N) making sure there is enough processing power and apart from that there are two 1 Gigabit Ethernet interfaces (1 interface in the 5N) for quick transfers. Drobo is keen on making their NAS as easy to use as possible. One key feature is the possibility to add disk drives of different sizes to an array.
Back last year we've had the predecessor of the Drobo 5N2 for review, which went by the name 5N. Meanwhile it's about time to have a look at the successor and check what the NAS manufacturer has changed and what remained the same. At a first glance it looks like not was touched but still on the performance side there was an upgrade with a new and more powerful processor and a second Gigabit Ethernet interface has been added as well, bringing fail-over redundancy or higher network performance to the table. Apart from that the 5N2 from Drobo is a NAS that has been optimized towards eas of use - like the predecessor. Therefore you get a sleek looking product offering basic features from the hardware perspective. Apart from that there is Drobo's so called BeyondRAID feature as well as an mSATA connector and we're certainly going to have a closer look those goodies. Apparently we wil also have a look at performance, which used to be the achilles heel of Drobo's consumer offerings in the past.
| Page 1 - Introduction | Page 5 - Software |
| Page 2 - Preview | Page 6 - Test Setup |
| Page 3 - Specifications | Page 7 - Test Results |
| Page 4 - Delivery | Page 8 - Conclusion |
Preview
| Page 1 - Introduction | Page 5 - Software |
| Page 2 - Preview | Page 6 - Test Setup |
| Page 3 - Specifications | Page 7 - Test Results |
| Page 4 - Delivery | Page 8 - Conclusion |
Specifications
| Processor | Quad Core Marvell Armada, 1.6GHz |
| HDD Capacity | up to 5 x 3.5" SATA II/III HDD or SSD + 1 mSATA acceleration SSD |
| HDD Trays |
|
| LAN Ports | 1 x Gigabit RJ-45 Ethernet port |
| LED Indicators | Yes |
| Buttons | Power Button |
| LCD Panel | Yes |
| Dimensions | 262.3(D) x 150.3(W) x 185.4(H) mm |
| Weight | 3.9 kg |
| Power Supply |
|
| Fan | 1 x 120 mm |
Software and Features
| Networking Protocols |
|
| Supported RAID Type |
|
| Software Features |
|
| BeyondRAID Features |
|
| Supported OS |
|
| Page 1 - Introduction | Page 5 - Software |
| Page 2 - Preview | Page 6 - Test Setup |
| Page 3 - Specifications | Page 7 - Test Results |
| Page 4 - Delivery | Page 8 - Conclusion |
Delivery
- 1 x Drobo 5N2
- 1 x Power cord
- 1 x Ethernet cable
- Manual
Included in the delivery of the 5N2 there is everything you need to setup the device straight away and properly. The front of the Drobo 5N2 features a sleek face plate, which is being kept in place by magnets. Taking off the black, plastic face plate gives you access to the five drive bays, which allow for tool-less installation of up to five drives. The front also comes with different LEDs, which indicate the status of each hard drive, inform about malfunction and monitor power.
Turning the Drobo 5N2 around shows that there is a 120mm fan. The fan is silent but not inaudible. We would love to see a Drobo use a more silent fan, which doesn't have any bearing noise. A closer look at this side of the devices shows two RJ45 Gigabit Ethernet ports, the power button and one DC IN plugs for the power supply. As far as the hardware is concerned, the Drobo 5N2 is based on a Marvell Armada embedded CPU. This particular model features four cores, clocks at 1.6GHz.
BeyondRAID
In order to understand the advantages and also to a certain extent limitations, one needs to undstand the limitation of RAID arrays. In the case of a normal RAID array all drives need to be of the same capacity. In the example of a RAID1 with one 4TB and one 6TB drive, you will end up with an array capacity of 4TB, wasting 2TB. If you would like to change the RAID mode at a later stage you'll have to destroy the old array, losing all the data on your drives, to then create a new array. Apart from that there is another limitation, which concerns the physical migration of a RAID array. In such an event you would have to make sure that the drives are inserted in the same order the were in the old device, otherwise the array is not being recognized.
BeyondRAID from Drobo offers the possibility to combine drives of different sizes in an array. Depending on the security level you choose, either the loss of one or two drives is protected. If you wish to migrate your array to a new device, you will not have to make sure you're using the same drive order. BeyondRAID is capable of recognizing the array even if the drive order has been changed, which makes upgrading to a new device much easier. Yet another advantage of BeyondRAID is that the protection level can be changed on-the-fly, removing the necessity of destroying the array before switching the protection level.
Regarding limitations of BeyondRAID we have a quick look at how the protection issue is addressed, meaning how much parity data needs to be saved. This depends on the security level you choose. If you decide to enable single-drive-protection then the capacity of the largest drive in the array will be reserved. In the case of dual-disk-protection the capacity of the two largest drives will be reserved. In our case Drobo shipped the 5N2 with the following drives: 1TB, 2TB, 2TB, 4TB and 6TB. If we choose single-drive-protection then 6TB and in the case of dual-drive-protection 4TB+6TB, 10TB respectively will be reserved.
mSATA acceleration SSD
To increase performance Drobo equipped this unit with a nifty little feature. Sheer throughput and IOPS used to be the achilles heel of Drobo NAS for the consumer market. In combination with a quad core embedded CPU there is now plenty of calculation power, which allowed the implementation of SSD caching. If you wish to make use of this functionality you can flip the device over and access the mSATA SSD slot at the bottom. Once the drive has been installed and the 5N2 booted, it's automatically being configured. The whole process only takes a few minutes and then enables massively boosted IOPS performance and also the throughput performance benefits. When we wanted to try this feature we unfortunately weren't aware that not all mSATA SSDs are compatible and our SandForce SF-2281 based drive wasn't working. Therefore we strongly recommend to consult Drobo's compatibility list before purchasing a mSATA caching SSD.
In a second article on the Drobo 5N2 we will have a close look at the performance difference, when adding a mSATA acceleration SSD. Especially in the case of IOPS performance we're expecting a huge boost, whereas the sequential throughput should be bottlenecked by the 1 Gigabit Ethernet interface.
| Page 1 - Introduction | Page 5 - Software |
| Page 2 - Preview | Page 6 - Test Setup |
| Page 3 - Specifications | Page 7 - Test Results |
| Page 4 - Delivery | Page 8 - Conclusion |
Setup
Drobo combined the 5N2 with a software, which is compatible with PC and Mac. The user interface is simple and straight forward and configuration is as simple as it gets. There are no unecessary features also novice users will find their way through the software quickly. Once you started the software it automatically searches the local network for any Drobo device. Once recognized the status being displayed. As soon as you start adding hard drives, they're being configured according to the protection level you've chosen. If you decide to add another drive at a later stage it's automatically being recognized and added to the array, while parity data is being generated in the background. Once all drives are configured one can start setting up the shares with is a very simple process once again. The software is really simple to understand an in combination with the advantages of BeyondRAID the entire device can be set up by novice users without even consulting the manual.
| Page 1 - Introduction | Page 5 - Software |
| Page 2 - Preview | Page 6 - Test Setup |
| Page 3 - Specifications | Page 7 - Test Results |
| Page 4 - Delivery | Page 8 - Conclusion |
Test setup
| CPU | Intel Core i7-6700K |
| Motherboard | ASUS Maximus VIII Hero |
| RAM | 16 GB |
| Graphics card | Geforce GTX 980 Ti |
| SSD | Toshiba OCZ TR150 - 240GB |
| Ethernet Controller | Intel 1Gbit Ethernet |
| Page 1 - Introduction | Page 5 - Software |
| Page 2 - Preview | Page 6 - Test Setup |
| Page 3 - Specifications | Page 7 - Test Results |
| Page 4 - Delivery | Page 8 - Conclusion |
Test Results without Caching SSD
Crystal Disk Mark
| ALL 1000MB | Read MB/s | Write MB/s |
| Seq | 121.67 | 119.83 |
| 512K | 108.28 | 80.55 |
| 4K | 4.52 | 4.49 |
| 4K QD32 | 5.41 | 5.02 |
Power consumption / Noise level
Power consumption |
|
| Idle | 54 Watt |
| Load | 70 Watt |
| less is better | |
Noise level |
|
| Idle | 34.6 dBA |
| Load | 37.0 dBA |
| less is better | |
| Page 1 - Introduction | Page 5 - Software |
| Page 2 - Preview | Page 6 - Test Setup |
| Page 3 - Specifications | Page 7 - Test Results |
| Page 4 - Delivery | Page 8 - Conclusion |
Conclusion
At the price Drobo is asking, the 5N2 is a versatile and well performing NAS with five drive bays. The hardware used is a good compromise when it comes to a reasonable combination of performance and price. Thanks to BeyondRAID and a software for PC and Mac, this is simply the most user-friendly NAS we've had for testing so far. Apart from that it has been combined with a mSATA slot, which allows for acceleration through SSD caching. Especially IOPS performance benefits largely from a caching SSD. Unfortunately we had to realize that our mSATA SSD, which we use for testing isn't compatible with the 5N2. If you're interested in buying the 5N2 and a mSATA acceleration SSD, we highly recommend to check Drobo's compatibility list. Since our drive wasn't compatible we will create another article at a later stage, comparing standard and accelerated performance.
If you're looking for an efficient and quick NAS, then the Drobo 5N2 is simply the NAS, which was the easiest to configure. The BeyondRAID feature is just great, but we still recommend using drives with similar capacities. Like with a conventional RAID array quite some space can be wasted if the capacity differences are large.
The Drobo 5N2 is listed on Geizhals for about 535 Euro.
| Page 1 - Introduction | Page 5 - Software |
| Page 2 - Preview | Page 6 - Test Setup |
| Page 3 - Specifications | Page 7 - Test Results |
| Page 4 - Delivery | Page 8 - Conclusion |