Joining Cases

As I wanted a decent building to support the weight of the contents of both cases, decided to create a base with a metalon bar. The cases positioned side by side and fastened with staples to keep aligned.

I positioned the bars.

Close the fixing of lower bars, looking out of the case.

And inside

It was not of my interest fixing bars at the top, it would be difficult to hide them or give a finish that was less noticeable the bar there. The option I had was riveting the side of a case in the other, but I was afraid of not being enough for a good fixation. However, it was more efficient. The lower bar gave a very good stability, so that the rivets on the sides and top were enough.

Generally the lower fixing

And rivets at the top (the case is turned clockwise)

Generally the lower setting out the case, still without finishing.

Follows a video the whole process. Activate the closed caption
https://www.youtube.com/watch?v=kbbCZ1AqTh4