Lian Li PC-P50 Armorsuit
Published by Tanya Rothenburg on 18.11.09Page:
Back
Overview |
Features |
 |
 |
| On the backside you find an outtake fan with a diameter of 120 millimeters. Right below there are eight slot bezels located which should make the installation of a dual-slot-graphic card possible even if the card is put into the lowest slot. | The back 120mm fan extracts the hot air out at 1500 RPM. To reduce vibration noises to a minimum Lian Li provided the PC-P50 with a rubber mounting solution. Right next to the fan there are already two rubber covered holes for watertubes when using a liquid cooling system. |
 |
 |
| To exchange PCI cards, Lian Li has added snap closing clips. The part, where the clip-mechanism gets contact to the card, is equipped with rubber pads to reduce noise and keep it safe and tight in place. | The Power supply slot bars are coated with anti vibration rubber strips. The mounting clip is also aligned with rubber to reduce vibrations but also and also secure the PSU without scratching the painted surface. |
| Page 1 - Intorduction | Page 6 - Left side 2 |
| Page 2 - Preview | Page 7 - Right side |
| Page 3 - Front | Page 8 - Top / Bottom |
| Page 4 - Back | Page 9 - Conclusion |
| Page 5 - Left side 1 |
Discuss this article in the forums
| Navigate through the articles | |
Lian Li PC-X1000 |
Lancool K62 Gaming Case
 |
|
|